NEED Intel 3.04 FULLY UNLOCKED BIOS!! thx

[tombman]

If you have the 1073 (or 908) fully unlocked bios, which enables all overclocking options (vcore, power slope etc), pls send me a PM.
thx

[Dumo]

Heres will unlock the bios (thanks to FCG:toast: )...

Image #3...

http://www.xtremesystems.org/forums/showpost.php?p=1446099&postcount=1

[tombman]

NOT WORKING....vcore can be set, but won´t be supplied...

[kiwi]

Have tested it with MM?

Anyway, I don't know why you need to do vcore mod at all on rev 304. I have 304 board and all options are already available starting from 0908 bios.

[freecableguy]

@kiwi

are you using an XE/EE or non-Conroe ES chip? if so, that's why.

[kiwi]

Conroe E6600 ES

Old bios had no options though

[freecableguy]

hmm, well I had to do the mod on my rev 302 board with BIOS 0908 with a Conroe ES....looks like guidance is, do it if you need to! :)

[Silves]

Hi guys!
Do you notice that the temps reported by the D975XBX rev.304 are very high?
Mine (i have a E6300 ES), is always above 50ºc idle and near 60ºc in load.
and i only have 1.4v and the cpu is at 2750mhz, ive checked the contact between the cpu and the block (watercooling) and everything is fine and the cpu block is not that hot. Im i doing something wrong?

[freecableguy]

Hi guys!
Do you notice that the temps reported by the D975XBX rev.304 are very high?
Mine (i have a E6300 ES), is always above 50ºc idle and near 60ºc in load.
and i only have 1.4v and the cpu is at 2750mhz, ive checked the contact between the cpu and the block (watercooling) and everything is fine and the cpu block is not that hot. Im i doing something wrong?

I wouldn't believe them if I were you. I have found that the temps reported are 15-20C hotter on Conroe than actual temps (based on evap temperatures with a single stage unit).

[Silves]

Thanks for the feedback FCG, was getting paranoid with the temps.

[kiwi]

Yep, same here around 15-20C

[Dumo]

E6700ES stock @45C bios here.