[/QUOTE]PHP Code:******Gigabyte EP45 UD3 Template*******
Robust Graphics Booster [auto]
CPU Clock Ratio [8x]
Fine CPU Clock Ratio [+0.5]
**********Clock Chip Control***************
CPU Host Clock Control [enable]
CPU Host Frequency (Mhz) [542]
PCI Express Frequency (Mhz) [100]
C.I.A 2 [disable]
*********Advanced Clock Control**********
CPU Clock Drive [unchanged]
PCI Express Clock Drive [unchanged]
CPU Clock Skew [unchanged]
MCH Clock Skew [unchanged]
*******DRAM Performance Control********
Performance Enhance [turbo]
Extreme Memory Profile (XMP) [auto]
(G) MCH Frequency Latch [auto]
System Memory Multipler [2.00B]
Memory Frequency [1084]
DRAM Timing Selectable [auto]
CAS Latency Time [5]
tRCD [7]
tRP [7]
tRAS [24]
*******Advanced Timing Control***********
didnt touch ram timings auto
tRRD []
tWTR []
tWR []
tRFC []
tRTP []
Command Rate (cmd) []
***********Motherboard Voltage Control*******
Load-Line Calibration [disable]
CPU Vcore [1.46875V]
CPU Termination [1.500V]
CPU PLL [1.650V]
CPU Reference [0.935V]
MCH Core [1.600V]
MCH Reference [1.120V]
MCH/DRAM Refernce [0.990V]
ICH I/O [1.570V]
ICH Core [1.200V]
DRAM Voltage [2.100V]
DRAM Termination [auto]
Channel A Ref [auto]
Channel B Ref [auto]
Channel Timing Settings [B]didnt change[/B]
Static tRead Value []
tRD Phase0 Adjustment []
tRD Phase1 Adjustment []
tRD Phase2 Adjustment []
tRD Phase3 Adjustment []
tRD 2rd (Differnt Rank) []
tWR 2wr (Differnt Rank) []
tWR 2rd (Differnt Rank) []
tRD 2wr (Same/Difft Rank) []
Dimm 1 Clock Skew Control []
Dimm 2 Clock Skew Control []
DDR Write Training []
Channel Driving Settings
Drive Strength Profile []
Data Driving Pull Up Level []
cmd Driving Pull Up Level []
ctrl Driving Pull Up Level []
clk Driving Pull Up Level []
Data Driving Pull Down Level []
cmd Driving Pull Down Level []
ctrl Driving Pull Down Level []
clk Driving Pull Down Level []
*****************Advanced BIOS Features*********
CPU Multithreading []
Limit CPUID Max to 3 []
No-Execute memory Protect []
CPU Enhance Halt (CIE) [disable]
C2/C2E State Support [disable]
C4/C4E State Support [disable]
CPU Thermal Monitor [enable]
CPU EIST Function [disable]
Virtualization Technology [enable]
heres my setup for 4.6GHz
4.4GHz and 4.5GHz r about the same with less vcore the termination
Reply With Quote
Originally Posted by EliTE22
, on 4.6 id ENABLE Load-Line Calibration because of random freezing, seem to fix it, have not run prime for more than 15min, will hopfully test it latter, 
Bookmarks